Bus coupler - MPNC010

MPNC010 is modular system with CANopen interface. The whole system is made by a coupler/controller MPNC010 and a set of Terminals for different kind of signals: MPNC020 for digital signals and MPNC030 for analogue signals.

GENERAL DESCRIPTION
The coupler processes data gathered by Terminals and make them available through the CANopen interface it provides. The coupler can be connected to both analog, and digital Terminals, MPNC030 and MPNC020; communication between them is provided by an internal bus, named TBUS. All modules must be attached directly onto a DIN rail type EN 50022 (DIN 35) on which their TBUS connection modules were properly inserted.
TBUS connection modules perform internal communication between the bus coupler MPNC010 and terminals. For each coupler / controller you can enter up to a maximum of 12 terminals.
The MPNC010 coupler is made bt:
• power supply and isolation modules that provides supply voltage to the TBUS and to the fieldbus interface
• CANopen bus interface
• 8 positions DIP switch to configure address and baudrate
• 4 status LED
• Internal communication interface (TBUS)

​

Download Bus Coupler MPNC010 Series User Manual - 
http://www.mect.it/dati/file/prodotti/58_BUSCOUPLER_EN.pdf​

TECHNICAL CHARACTERISTICS
Protocol: CANopen
Configuration: from PLC 
I/O maximun number: 1.024 Input/1.024 Output 
Max baud rate: 1Mbit/sec 
Operating modes of process data: synchron, cyclic, event driven, polling 
PDOs (CANopen) number: 16TX/16RX 
Powe supply: 24Vdc ±15%, 1W 
Dimensions: 115(l)x115(h)x45mm(depht) 
Working temperature: 0÷50°C 
Protection: IP20