FLASH POINT CHECK
Order Code: T 750 - Closed Cup/ Pensky-Martens-Method
The identification of possibly hazardous liquids is a safety issue in manifold applications. The Flash Point Check allows this both directly on-site and right on-time where and when flash point verification of mineral oils is required.
The identification of possibly hazardous liquids is a safety issue in manifold applications. The Flash Point Check allows this both directly on-site and right on-time where and when flash point verification of mineral oils is required.
Features:
- Measuring range: 25 - 200 °C
- Measuring time: about 15 min.
- accuracy: +/- 2 % < 100 °C, +/- 6°C > 100 °C
- Closed cup method leaning on ISO 2719 DIN EN 22719 and ASTM D-93
- Flash point read-out in °C
- Approved by German Navy for field use
- Handy to use on site
The FLASH POINT CHECK consists of a Closed Cup (PM) flash point tester as specified by ISO, DIN, EN and ASTM. It is designed to be used either with the electrical heater provided or to determine flash points below 65 degrees C, it can be heated to 100 degrees C by placing it in an external oven or hot water bath.
